tightening down the 3rd brake light

themadness · Post by **themadness** » Thu Sep 22, 2011 5:13 pm

that sum-bich is flopping around on the back deck like an epileptic at a strobe light convention. do i have to take the seats out to get to the back panel to tighten it down?

DTMAce · Post by **DTMAce** » Thu Sep 22, 2011 6:18 pm

There are 2 screws, one on each side near the base. That is all that should be holding it on. But I highly doubt you need to remove the seat at all. Other way to get to it, is from underneath the deck from the trunk.

themadness · Post by **themadness** » Thu Sep 22, 2011 6:38 pm

the 2 at the base are tight and i didnt see anything to tighten under the deck.

scd88ga · Post by **scd88ga** » Fri Sep 23, 2011 6:40 am

themadness wrote:the 2 at the base are tight and i didnt see anything to tighten under the deck.

That's because it screws down on top of the the rear deck, it's a metal bracket. Remove the two side screws from the light housing and take the assemble out.

Beretta.net