Where do the heater core lines run to?
Where do the heater core lines run to?
I cannot seem to find any undone lines anywhere. As you may know from my previous post, a line burst on my heater core when i was driving down the road and to replace it i need to find where these lines go to. Can someone please help.

1989 Beretta Base 2.8
-
- Global Moderator
- Posts: 1991
- Joined: Sun Nov 03, 2002 4:10 pm
- Location: Concord, NC
- Contact:
Re: Where do the heater core lines run to?
Ace was correct in the other thread; there are two plastic lines coming out of the heater core, those typically fail after repeated heat cycles and crack/leak. Or the plastic end tanks on the heater core do the same thing.
Geoff
95 Z26 Turbo 3400 5spd - R&D Project
Beretta Preservation Society - Director of Acquisitions

95 Z26 Turbo 3400 5spd - R&D Project
Beretta Preservation Society - Director of Acquisitions

Re: Where do the heater core lines run to?
They go through the firewall into the heater core, near the bottom of the firewall, toward the driver's side. You may have have to lift the front end up and get underneath to get to them because of all the stuff on top and behind the engine depending on what engine you have.
Re: Where do the heater core lines run to?
Actually I was wondering where the other end of the lines go to from the heater core. I'm asking because I have to locate the lines because when the metal clip broke the line came off when I was driving. 2.8 multiport

1989 Beretta Base 2.8
Re: Where do the heater core lines run to?
They both start at the top of the water pump housing - one line runs across the front of the engine, through the throttle body, and down the drivers side of the block, the other comes from on top of the water pump and down the right side of the car and along the firewall.
Re: Where do the heater core lines run to?
Thanks ronaconda and everyone else. now i just have to find the line.

1989 Beretta Base 2.8
- 3X00-Modified
- Administrator
- Posts: 10916
- Joined: Thu Jul 05, 2007 9:18 am
- Location: Brooklyn CT
Re: Where do the heater core lines run to?
What "line" are you speaking of?
Re: Where do the heater core lines run to?
I was confused earlier. I thought that the drain tube was something else. I hope im not irritating everybody. Im just new to this. I already have the Haynes manual in the car and im buying a spectra heater core later on today. and again, Im sorry if i'm irritating everyone.3X00-Modified wrote:What "line" are you speaking of?

1989 Beretta Base 2.8
- 3X00-Modified
- Administrator
- Posts: 10916
- Joined: Thu Jul 05, 2007 9:18 am
- Location: Brooklyn CT
Re: Where do the heater core lines run to?
no irritation, just a simple mistake, but make sure to read everything that people are taking the time to post, it will save you a headache and also eliminate unnecessary questions like this.
Re: Where do the heater core lines run to?
Thanks everyone for the help and I will be sure to read the entire post from now on.

1989 Beretta Base 2.8