Intake spacer info

Money pit Beretta · Post by **Money pit Beretta** » Tue Oct 16, 2012 6:27 pm

I see on 60* that 03sleepr is selling some intake spacers. I have no way to contact him if I want them. What I must ask is how thick are these? Can I use them on my Beretta without the upper touching the hood?
They do look to be in good shape. I was thinking of making my own gaskets that are port matched and I think the spacers may be better. I just didn't have the time to port match my 3400 intakes before I put them on. Nor did I have the time to do it when I had to do the LIMG again.

Post by **3X00-Modified** » Wed Oct 17, 2012 8:27 am

Yes it will clear the hood... its only close to a stock hood with the 3500 upper intake but still clears if you have stiff engine mounts...

Money pit Beretta · Post by **Money pit Beretta** » Wed Oct 17, 2012 11:44 am

Boy I got lucky on that one, I was thinking about PM'ing you. Thank you for the info.
Just a few more things to ask. Are the ports on the spacers the same size as stock or ported? Is he a member here under another name? If not can someone here contact him? If the ports are the same size as stock am I going to need longer bolts?

99GaGT3X00 · Post by **99GaGT3X00** » Wed Oct 17, 2012 3:03 pm

you would need longer bolts. IIRC the you can gasket match the spacers but then you need to run gaskets on either side since you won't be able to use the o-ring setup anymore.

gasket match them and use the paper gaskets on each side. i got a set like the ones that 03sleeper is selling and that's how i have been running them for awhile now.

Money pit Beretta · Post by **Money pit Beretta** » Thu Oct 18, 2012 6:51 pm

Looks like Robert is going to get them.

Beretta.net