studdering for a start
studdering for a start
Well today out getting hardware for a new project of mine, my car start shuddering right when you take off around 1k-3k. What happened? Coil pack? Ignition?
- SuzukiGhostRider
- Registered User
- Posts: 2464
- Joined: Tue Feb 12, 2008 4:07 am
- Location: Milan NM
- Contact:
studdering for a start
I have no check engine light. It shakes REALLY bad when you start and ti wont accel. like it used too.
studdering for a start
sounds like a coil went out. Do you smell raw fuel coming from the exhaust? There are pleanty of explinations of how to test the coil
John
'01 Duratec Sable Wagon
'01 Duratec Sable Wagon
studdering for a start
Well like it only does it under a heavy load i.e. floorin it but if you take it real easy to start it won't do it. I replaced the O2 like a week ago.
- berettaspeed15
- Registered User
- Posts: 27
- Joined: Sun Sep 16, 2007 3:51 pm
- Location: STL
studdering for a start
how old are the plugs and wires?
- SuzukiGhostRider
- Registered User
- Posts: 2464
- Joined: Tue Feb 12, 2008 4:07 am
- Location: Milan NM
- Contact:
studdering for a start
Sounds like a miss to me. I would check fuel pressure and plugs/wires as Berettaspeed suggested. Since it only does it when floor boarded, I would almost say one or more of your cylinders is getting flooded out or fuel starved. Not the O2 though as it's bypassed under WOT. GL.
studdering for a start
Wires are like a few months like 2-3. Guess what happened this morning...
I went out to get in my car to go to school start it up, put it in D rolls back. Didn't engage Drive so I had to drive my parents car to school. Then when I got home started it up, put in D, Engaged FINE and drove off. I was mad as a bat out of hell this morning. I threw some new trans fluid in it and it seems to help. I'll have to see tomorrow.
I went out to get in my car to go to school start it up, put it in D rolls back. Didn't engage Drive so I had to drive my parents car to school. Then when I got home started it up, put in D, Engaged FINE and drove off. I was mad as a bat out of hell this morning. I threw some new trans fluid in it and it seems to help. I'll have to see tomorrow.
- SuzukiGhostRider
- Registered User
- Posts: 2464
- Joined: Tue Feb 12, 2008 4:07 am
- Location: Milan NM
- Contact:
studdering for a start
Hmmm...with that little piece of info, I now believe your tranny to be the source of your troubles. I wonder if you have some slippage issues or if it was just low on fluid... Time to call the trans experts. (Yells for Fastlane , LuckyMC , and 3400modified). Ask these guys, a tranny man I'm not for the most part.
studdering for a start
1989 2.8/3t-40
It worked fine today. Weird. But oh well, glad it doesn't need a new one.
It worked fine today. Weird. But oh well, glad it doesn't need a new one.