Thread closed (lulz) giving update on situation

nikosuave8896 · Post by **nikosuave8896** » Sat Sep 10, 2011 7:46 pm

Okay everyone my thread got completely attacked with posts so im here to update on my cowl situation

I went out and bought 3m windshield sealant and man that stuffs sticky lol. I took off the cowl and vacumned it out and apploed the sealant everywhere i could even near the windshield hoses etc anywhere i could think that had cracked sealant. I also put some where the windshield was at the bottom where the cowl piece is. ( it.doesnt smear)

All went well applied what i could it should be better i did break the plastic cover things that hold the cowl in place , what size is it lol?
I broke 2 of em

Also please no arguging i just want to get a little more info and give an update

Also those arms were not fun to take off lol!!!

Sent from my Desire HD using Tapatalk

scd88ga · Post by **scd88ga** » Sat Sep 10, 2011 8:50 pm

The head on the plastic push pins are about the size of a penny, they stand just about an inch tall, and should work for a 3/16-1/4 inch hole.

DTMAce · Post by **DTMAce** » Sat Sep 10, 2011 9:09 pm

Napa sells those new. Cheap too.

90INDYLIN · Post by **90INDYLIN** » Sun Sep 11, 2011 12:22 am

Don't forget to seal on and around where the wires pass thru on the passengers side. Can cause leaks.

Post by **Cliff8928** » Sun Sep 11, 2011 12:49 am

That's where my source of leaks is on my '89. Newer models have a nice rubber boot over the wires so they don't leak through that bulkhead.

Beretta.net