what makes the cupholders stick

Keep this to general Beretta/Board/Community topics.
Post Reply
themadness
Registered User
Posts: 885
Joined: Sat Jun 18, 2011 9:48 am

what makes the cupholders stick

Post by themadness »

mine only opens about half the time and when it does it comes out half way. i usually have to open and close it 2 or 3 times to get it out.
User avatar
3X00-Modified
Administrator
Posts: 10916
Joined: Thu Jul 05, 2007 9:18 am
Location: Brooklyn CT

Re: what makes the cupholders stick

Post by 3X00-Modified »

old dried up sticky soda... Take it out and clean it.
Mr.Pink
Supreme Unit
Sleepy Goodness
"Beretta Guy"
themadness
Registered User
Posts: 885
Joined: Sat Jun 18, 2011 9:48 am

Re: what makes the cupholders stick

Post by themadness »

do those 2 screws hold just the cupholder in or does the whole panel with vents have to come out
User avatar
3X00-Modified
Administrator
Posts: 10916
Joined: Thu Jul 05, 2007 9:18 am
Location: Brooklyn CT

Re: what makes the cupholders stick

Post by 3X00-Modified »

the two screws hold it in and yes the two vents come out with it, there is a push in style clip between the two vents so you'll have to pull with some force to get it out after removing the screws.
Mr.Pink
Supreme Unit
Sleepy Goodness
"Beretta Guy"
User avatar
Styluss
Global Moderator
Posts: 2023
Joined: Tue Jan 24, 2006 6:48 pm
Location: Lakewood, Colorado

Re: what makes the cupholders stick

Post by Styluss »

Make sure to apply even force on each side of the cupholder unit so it doesn't snap in half on you while you're taking it out! And then yes, a simply spray down with some hot water from your kitchen sink will work wonders!
1989 GTU - The Nice Car
1989 Euro GTU - The Euro Car
1989 Base Model - The Rally Car
Post Reply