Canuck springs

Money pit Beretta · Post by **Money pit Beretta** » Tue Mar 03, 2009 6:38 pm

That's a good idea, but the whole front end needs to be rebuilt and I need to stay away from any extra cost. I'll keep it in mind though.

JeffD · Post by **JeffD** » Wed Mar 04, 2009 9:49 pm

What wrong with the front end? bad bushings?

Money pit Beretta · Post by **Money pit Beretta** » Wed Mar 04, 2009 10:59 pm

Man, everything has 150K on it, so it's all starting to get bad. I did put new tie rod ends on(Moog). The control arm bushings are not poping yet, but I can feel that they are going bad. I know this because I had them replaced on my old 90GT. Also the sway bar end links are new(one of the stock ones broke), but not the bushings on the bar. Everything was brand new on the 90's front end and it looks like the 95 is just a do over.

MY91GT(Z) · Post by **MY91GT(Z)** » Thu Mar 05, 2009 10:09 pm

does anyone know where to get intrax springs for 94 older for a decent price

Money pit Beretta · Post by **Money pit Beretta** » Thu Mar 05, 2009 10:55 pm

http://www.car-stuff.com/store/?Ntt=che ... ngs+intrax
I would not call that a good price though.

MY91GT(Z) · Post by **MY91GT(Z)** » Fri Mar 06, 2009 8:24 am

man i didnt think they would be that expensive

Money pit Beretta · Post by **Money pit Beretta** » Fri Mar 06, 2009 11:12 pm

If you look at the cost, the Eibachs are cheap and you can still get your floor jack under your car.

wicked-irocz · Post by **wicked-irocz** » Sun Mar 08, 2009 11:50 pm

you can use FE3 springs from the 95-96 and they drop the same amount as a older FE3 setup and have a higher spring rate up front than the FE7.

Money pit Beretta · Post by **Money pit Beretta** » Mon Mar 09, 2009 12:16 am

Thanks wicked! Do you know what the GM part #'s are? I know of a site online where I might be able to get them. If the cost is close to the Eibachs and the ride is better I may get them.

wicked-irocz · Post by **wicked-irocz** » Fri Mar 13, 2009 3:44 pm

just go get a set at the JY or put up a wanted add, everyone throws them away when they put on aftermarkets.

Money pit Beretta · Post by **Money pit Beretta** » Fri Mar 13, 2009 11:45 pm

I would like to get new springs. There are a few places that I know of that might have them, but I need the part #'s to check.

Connect with your social network account