Project 91 "SS" 3400/5spd

[scd88ga]

There are no bolts holding it in...it's an M-shaped clip that slides over the recesses in the cables. I think the only thing that holds it down is the console.

Oops, my bad, I thought you meant under the hood, I falling asleep while on here last night. Hose clamps work too, lol I might have and extra M-shaped clip here somewhere, I usually keep them when i pull shift cables at the yard. If yours is broken or worn let me know. I know that spring metal can lose tension over time and doesn't take lightly to bending back into shape...

[SummitBalt08]

They sell those m style clips at menards so most hardware stores should have them

[scd88ga]

They sell those m style clips at menards so most hardware stores should have them

Thanks! That's good to know, it is now logged into my Rainman memory.

[Cliff8928]

There are no bolts holding it in...it's an M-shaped clip that slides over the recesses in the cables. I think the only thing that holds it down is the console.

I think i still have a ton of those somewhere... When i changed mine i think I had to buy a pack of 10 or something like that.

[woody90gtz]

Wasted money on an alignment yesterday. My beer can alignment was already within spec. They adjusted my toe 1/32" and camber by .1 and .2* is all. haha

[99GaGT3X00]

My beer can alignment was already within spec.

haha first i ever heard of that method.

[woody90gtz]

Jon got me to look it up. Apparently it works quite well. haha

[woody90gtz]

Muncie FAIL. Broke the 5spd on my third pass at LVD today...so it's done for the year. I won't know for sure until I pull the trans...but I think it's stuck in 3rd and 4th gears.

Ran 14.56@94.8 first run with an easy launch. Second run I launched a little higher with a 2.21 60' and a 14.46@@92.3 with 4th gear problems. Last run it went 19.47@42.3 limping it off the track. The place was packed so I didnt get as many runs as I wanted, but I liked the clutch. The new braided slave line make it much better to beat on. The MPH was a little lower than I expected, but my 60's were getting better...and it probably would have done a 14.2 without trans trouble.

[weba]

Are you sure it's not the cable?

[MY91GT(Z)]

X2 on what weba said but u got some decent times at least hopefully u have more time to make it to the track next year

[woody90gtz]

100% positive it's not the cable. I tried changing gears on the shift arms on the trans and it will "shift" to 3-4 but no others. And when you try to take off in whatever gear(s) it's stuck in, it's bound up tight. The only way to move it is with the clutch disengaged.

I'm wondering if I bent a shift fork or something.

[KFLO 93 GT]

Time to build an otto?

[woody90gtz]

I already talked to Barry about buying his 5spd. I can either go internal slave with his equipment or convert it to external with my bellhousing. I'm gonna rebuild it and install my LSD anyway...

[DTMAce]

Didn't you have or end up with a bent set of forks the last time? Or was that someone else?

[woody90gtz]

Clutch fork, yes...due to my own stupidity.

This is probably a shift fork. Cause unknown.