thunk clunk pop
- berettajunkie1991
- Registered User
- Posts: 217
- Joined: Sat Jul 16, 2005 1:40 am
- Location: Illinois
- Contact:
thunk clunk pop
hey when im slowing down i feel this popping in the floorboards and it feels like the right wheel, it does it when i stop or slow driving. or when i put it in reverse the car shifts like something pops in when i back up with the wheel cut to the left any ideas im thinkin a ball joint possibly the half shaft was replaced or could it be a mount. the GTZ has about 166,000 miles and it has auto trans.
- Luckymc420
- Registered User
- Posts: 489
- Joined: Mon Jul 10, 2006 1:31 pm
- Location: Des Moines, Iowa
thunk clunk pop
I would check the CV (Constant Velocity) Joint.  My left side started to do that.  Does it make noise when you turn right? Also does it pop like in Pop and thats it or is cont...
Then when you back up does it pop when you are putting it into gear or when you turn the wheel?
Then when you back up does it pop when you are putting it into gear or when you turn the wheel?
Project B!
1991 5-Speed Beretta with a 2002 3400 OBDII In progress.....
1991 5-Speed Beretta with a 2002 3400 OBDII In progress.....
- berettajunkie1991
- Registered User
- Posts: 217
- Joined: Sat Jul 16, 2005 1:40 am
- Location: Illinois
- Contact:
thunk clunk pop
i put a new cv axle in so it is not that im thinking it is the motor mount because it feels like when you pull a bolt through metal so thats what i think
- docrodg
- Registered User
- Posts: 137
- Joined: Mon Aug 28, 2006 10:09 pm
- Location: California and New York
thunk clunk pop
Sounds like the motor mount. IF you replaced the whole right axle then the try and cv joints must be good. Check the left one to be sure, just grab it and twist and see if it has play. The motor mount is easy to check, have someone move the gear selector between R N and D wile you watch the engine for movement.